I hate build-up that gathers around lids of finish. Pick any finish. Whether it’s, paint, shellac, lacquer or something else, if you pour it from a can, sticky goo comes to visit. As you pry open the often-stuck lid, crap gets on your screwdriver or on your hands or gloves. Goo is easily transferred to your project and that’s worse than glue spots – OK, nothing is worse than glue spots.
If you think all you have to do is use a brush to clean the rim as you put the can away, you’re wrong. Junk, partially dried to become sticky, remains in the rim valley. If it would simply dry, it would be good. That’s not the case. For years I suffered with gooey can rims, but no more. I discovered a secret.
Take a nail then puncture about four holes per quart can, or five holes per gallon can directly through the valley formed at the rim. It’s easy. A couple taps with a hammer and you’re through. (You can use a big-boy hammer if you do not have one from a kids tool set like I do – remember these?) After you have your holes made, any product left in that valley seeps back into the can. Now you know why a #4 nail hole doesn’t do the job.
It’s even better as you replace the lid. Any product left in the rim is then forced through your holes and not over the rim only to run down the can. You can only imagine the sounds made inside the can as you hammer the lid; a giant squishing noise as shellac spurts back into the can. With the lid in place, no air seeps into your can to ruin the product. It’s so clean.
Build Something Great!